PCD-90ABCDWaterproof Metal Access Card Reader
It can wrok with power supply,also can connected with the electronic lock,access control panel
Users Manual for RFID Card Reader
Specification
Working Voltage DC 9V-16V
Static Current ≤80mA
Reading Range 5~10CM
Support EM-ID,M1card,15693card,and 1443A,1443B Card
Ambient Temperature -10°C~50°C
Ambient Humidity 10%~90%
International Standard Wiegand Interface
small than 100M Communication Distance
Installation
Using “+”type screw driver to loosen the screw between the panel and motherboard. And then embed the motherboard to the side wall with the plastic plug and screws.
Wire Connection
WG26/34 RS485 RS232
Red DC 9V-16V Red DC 9V-16V Red DC 9V-16V
Black GND Black GND Black GND
Gree D0 Green 4R+ Green RX
White D1 White 4R- White TX
Blue LED
Yellow BEEP
gray :ring
purple:ring
Notice!
1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of power supply
2. When external Power is used, make sure sharing the power with Controller Box or using the same GND
3. The wire connects reader to controller, advise use 8 cores stranded twisted pair cable(among them, three strands are spare, if no need reader show illegal card s by sound and light, LED wire can not be used, data wire Data1 Data0 are twisted pair would be better, we suggest sectional area are 0.22 square millimeter at least. The length should not exceed 100meters.
shielded wire connect to GND o
Accessories
User Manual 1
certificate of compliance 1
Quantity Per Month: 10.000pcs
Delivery Way - Date Of Delivery: within 2 working days